1.6" (38mm) Thin-Wall Fiberglass Mini Frenzy Dual Deploy
Great Starter Rocket
Posted by Mark on 20th Jul 2017
I purchased and built this as my first fiberglass model. I had a great time with it. Because the F level motors don't give a whole lot of thrust I had more reliable flights flying it is a single deploy without the upper tube.
Posted by rharshberger on 13th Mar 2017
Just finishing up the build on this fun little rocket. Assembly was pretty much by the instructions. The only fitting that I had to do was to open up the fin slots a bit as they were too tight to for the fin to slide into, the kit came with everything but the motor retainer and parachutes, it did include all the hardware, removable rivets, and recovery harness materials. I have seen a couple of these rockets flown at our clubs launches and they fly beautifully. The Altimeter bay will take a bit of pre-thought to make work as its very tight, I used a Eggfinder Quantum and a LiPo, with the sled mounted on only one all-thread so that the other passed above the altimeter and battery. This is my second Frenzy rocket and I really enjoy them.
Fiberglass 5:1 Ogive Nose Cone
Pre-Slotted Lightweight Thin-Wall Fiberglass Airframe
G10 Fins and Centering Rings
Kevlar/Nylon Shock Cord
Motor Mount: 29mm
Fins: 1/16" G10
Optional Recovery System:
18" Quality Nylon Chute (1)
10" Drogue Chute (1)
6x6 Chute Protector (2)
Optional Tether System:
These Shock Cords are about as good as it gets. They are 100% Kevlar! The loops are sewn at both ends with High Performance Kevlar thread then further protected and strengthend with a high heat protective shielding. The shielding protects the loop/thread plus also prevents fraying of the ends. One tether has one end open to attach to the motor tube. Tether is rated @ 1200lbs. Tether is approximately 10' long. Comes standard with a 600Lb Swivel at one end.